Views: 0 Author: Site Editor Publish Time: 2023-12-21 Origin: Site
Fireproof board can also be called Fireproof board, its scientific name is a laminate of thermosetting resin-impregnated paper high-pressure layer. An Air duct plate of central air conditioner is a kind of refractory building material for surface decoration. It has very rich surface colors, textures, and special physical properties. It can be widely used in indoor decoration, furniture, kitchen cabinets, laboratory countertops, and exterior walls. Next, let's take a look at the manufacturing process and construction maintenance of a Fireproof board.
Here is the content list:
The manufacturing process of a Fireproof board
Construction and maintenance of Fireproof board
The manufacturing process of a Refractory phenolic foam board is made of decorative paper and kraft paper through impregnation, drying, high temperature and high pressure, and other processing steps. Firstly, impregnate the decorative paper and kraft paper in the reaction tanks of melamine resin and benzene resin respectively. . After soaking for some time, they are dried separately and cut into required sizes. Then stack these impregnated decorative papers with multiple sheets of kraft paper (depending on the thickness of the Fireproof board), and place them under the press. At 300 degrees Fahrenheit (about 150 degrees Celsius), apply a pressure of 1,430 pounds per square inch for an hour of constant pressure. Then it is made by trimming, sanding, quality inspection, and other steps.
When installing the panels, the material must bring it up to room temperature and maintained at a stable temperature. The material should not be installed in a location with a temperature significantly different from that of normal use. Fireproof board decorative panels and ceilings are indoor decoration products, designed for installation in normal-use spaces at 15°C-30°C, and the relative humidity should not exceed 70%. All plaster, cement, terrazzo, or other wet work must be properly placed. Before, during, or after installation, the HVAC system must be properly installed and operational to maintain normal temperatures. It is not recommended to use insulation to cover the ceiling or support the insulation with the ceiling. Under conditions of high relative humidity, the additional weight on the ceiling may cause the ceiling to sag. If the project needs to use such insulation materials, it must be used in a normal environment with a temperature of 15°C-30°C and a relative humidity of up to 70%. The weight of the insulation material is limited to a maximum of 1.269kg/m2, and only coil insulation material can be used. And it must be installed vertically in the fulcrum of the skeleton to support the weight of the insulation material.
The maintenance of a Fire insulation board is similar to that of ordinary painted ceilings, but when maintenance is required, to ensure the high performance, effect, and beauty of the ceiling, please be sure to follow the prescribed methods. Dust or loose soil should be cleaned with a brush or a vacuum cleaner. The accessories of the vacuum cleaner should be of the type that absorbs the curtain cloth or the wall. It must be cleaned in one direction to avoid rubbing the dust into the ceiling surface. After the dust is cleaned, such as lead marks, dirty spots, or attached dirt can be wiped off with general art glue. If you use a high-quality wall cleaner to wipe, the water in the sponge should be squeezed out as much as possible. After wiping, the thin touch of the cleaner can be cleaned with a rag or a sponge slightly dampened with water.